National Loop Co. 28' (4' X 10') Saw Cut Vehicle Detection Loop with Custom Length Lead-In for 14' Wide Driveways - P-NL14-18

National Loop Co. 28' (4' X 10') Saw Cut Vehicle Detection Loop with Custom Length Lead-In for 14' Wide Driveways - P-NL14-18

Monitoring the driveway around the clock, the National Loop Co. 28' Saw Cut Vehicle Detection Loop with its custom length lead-in covers the lane with dependable non-contact detection. Installers groove the existing drive, tuck the loop into the slot, and close it up with loop sealant. With 28' of wire laid out 4' x 10', it covers the lane on 14' wide driveways such as long rural drives and roomy single-car or snug 2-car lots.
Part Number: P-NL14-18

* Required Fields

$117.60 each $117.60 each

Price From: $117.60

Details

National Loop Co. 28' (4' X 10') Saw Cut Vehicle Detection Loop with Custom Length Lead-In for 14' Wide Driveways - P-NL14-18

Because it arrives prewound and precut, the National Loop Co. 28' Saw Cut Vehicle Detection Loop with Custom Length Lead-In takes the guesswork out of adding vehicle detection to an existing driveway. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator dependable non-contact detection. Installation calls for sawing a 1/8" slot 1" deep into existing asphalt or concrete, laying the loop in the slot, and sealing it, with no hand-winding or turn counting required. With the 10' side crossing the lane and about 2' of clearance per edge, and the 4' side capturing vehicles in the direction of travel, the layout fits wide single-car or tight 2-car driveways and long rural drives.

Features:

  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
  • Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
  • Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range

Specifications:

  • Loop type: Saw cut
  • Total loop length: 28'
  • Loop dimensions: 4' x 10'
  • Lead-in length: Custom length
  • Slot size: 1/8" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 14'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number P-NL14-18?

Required Fields *

Name *

Email *

Phone

My Questions *