National Loop Co. 76' (6' X 32') Saw Cut Vehicle Detection Loop with Custom Length Lead-In for 38' Wide Driveways - P-NL38-18

National Loop Co. 76' (6' X 32') Saw Cut Vehicle Detection Loop with Custom Length Lead-In for 38' Wide Driveways - P-NL38-18

The National Loop Co. 76' Saw Cut Vehicle Detection Loop with Custom Length Lead-In sends a signal to the gate controller whenever a car or truck crosses its wire. It sees the vehicle without touching it. Crews cut a narrow channel in the existing driveway, set the factory-wound loop inside, and seal it against moisture. With 76' of 18 AWG wire laid out 6' x 32', it matches 38' wide driveways, including grain elevators, agricultural co-ops, and wide equipment yards.
Part Number: P-NL38-18

* Required Fields

$198.25 each $198.25 each

Price From: $198.25

Details

National Loop Co. 76' (6' X 32') Saw Cut Vehicle Detection Loop with Custom Length Lead-In for 38' Wide Driveways - P-NL38-18

A preformed 18 AWG inductive loop built for saw-cut installation, the National Loop Co. 76' Saw Cut Vehicle Detection Loop with Custom Length Lead-In detects vehicles passing over the driveway. Wired to a compatible automated system, the loop detects the metal of any vehicle over the sensing area so the gate stops or reverses before contact. The install method is a 1/8" wide, 1" deep saw cut in the existing asphalt or concrete, with the loop laid in and sealed to finish the job. Its 32' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to wide equipment yards, grain elevators, agricultural co-op entrances, and large commercial plaza entries.

Features:

  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
  • Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
  • Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range
  • Neatly stacked turns accept loop sealant completely, locking out moisture for long service life

Specifications:

  • Loop type: Saw cut
  • Total loop length: 76'
  • Loop dimensions: 6' x 32'
  • Lead-in length: Custom length
  • Slot size: 1/8" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 38'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number P-NL38-18?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Loop Length Size 6' X 32'
Total Loop Length 76'
Wire Size 1/8"
SKU P-NL38-18
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Manufacturer National Loop Company - NLC