Details

National Loop Co. 92' (6' X 40') Saw Cut Vehicle Detection Loop with 50' Lead-In for 46' Wide Driveways - X-NL46-18-50

Gate installers can turn an existing driveway into part of the safety system with the National Loop Co. 92' Saw Cut Vehicle Detection Loop with 50' Lead-In, a preformed 18 AWG inductive loop. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator the non-contact detection that fills one of the two UL 325 entrapment protection slots. Setup is a 3-step process: saw a 3/16" slot 1" deep in the pavement, press the loop in, and seal over it. Its 40' side detects a vehicle anywhere across the lane, while the 6' side tracks its passage, with roughly 3' of edge clearance, ideal for freight terminals, large agricultural processing plants, and wide estate boulevard gates.

Features:

• One continuous, non-spliced XLP-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters

Specifications:

• Loop type: Saw cut
• Total loop length: 92'
• Loop dimensions: 6' x 40'
• Lead-in length: 50'
• Slot size: 3/16" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 46'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes