Details

National Loop Co. 76' (6' X 32') Saw Cut Vehicle Detection Loop with 225' Lead-In for 38' Wide Driveways - X-NL38-18-225

The National Loop Co. 76' Saw Cut Vehicle Detection Loop with 225' Lead-In is a preformed 18 AWG inductive vehicle detection loop that arrives ready to drop into a saw-cut slot. Once a loop detector reads its signal, the loop covers the non-contact vehicle detection that UL 325 requires as one of the two means of entrapment protection for automated gates. Setup is a 3-step process: saw a 3/16" slot 1" deep in the pavement, press the loop in, and seal over it. Its 32' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to wide equipment yards, grain elevators, agricultural co-op entrances, and large commercial plaza entries.

Features:

• Saves labor cost compared with winding a loop by hand in the field
• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding

Specifications:

• Loop type: Saw cut
• Total loop length: 76'
• Loop dimensions: 6' x 32'
• Lead-in length: 225'
• Slot size: 3/16" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 38'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes