National Loop Co. 76' (6' X 32') Saw Cut Vehicle Detection Loop with 125' Lead-In for 38' Wide Driveways - X-NL38-18-125
Details
National Loop Co. 76' (6' X 32') Saw Cut Vehicle Detection Loop with 125' Lead-In for 38' Wide Driveways - X-NL38-18-125
A preformed 18 AWG inductive loop built for saw-cut installation, the National Loop Co. 76' Saw Cut Vehicle Detection Loop with 125' Lead-In detects vehicles passing over the driveway. Paired with a compatible loop detector, it senses the metal mass of a passing car or truck and signals the gate operator to open, hold, or reverse, providing one of the two means of entrapment protection UL 325 requires for automated gates. Installation calls for sawing a 3/16" slot 1" deep into existing asphalt or concrete, laying the loop in the slot, and sealing it, with no hand-winding or turn counting required. Its 32' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to wide equipment yards, grain elevators, agricultural co-op entrances, and large commercial plaza entries.
Features:
- Saves labor cost compared with winding a loop by hand in the field
- Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
- Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
- One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
- Factory-set turn count means optimal read range without any on-site adjustment
- Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
- Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
Specifications:
- Loop type: Saw cut
- Total loop length: 76'
- Loop dimensions: 6' x 32'
- Lead-in length: 125'
- Slot size: 3/16" wide x 1" deep
- Wire gauge: 18 AWG
- Wire material: Polypropylene-wrapped copper wire
- Best-suited driveway width: 38'
- Manufacturer: National Loop Company (NLC)
- Made in America: Yes
| Loop Type | Saw Cut |
|---|---|
| Lead-In Length | 125' |
| Loop Length Size | 6' X 32' |
| Total Loop Length | 76' |
| Wire Size | 3/16" |
| SKU | X-NL38-18-125 |
| Product Type | Saw Cut Preformed Loop |
Made In America
Learn More About BABA Certification
|
Yes |
| Ideal Application | Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters |
| Material | Polypropylene-Wrapped Copper Wires |
| Manufacturer | National Loop Company - NLC |
| Specification Sheet | Download PDF file |