Details

National Loop Co. 68' (6' X 28') Saw Cut Vehicle Detection Loop with 50' Lead-In for 34' Wide Driveways - X-NL34-18-50

Made for gate and access-control upgrades, the National Loop Co. 68' Saw Cut Vehicle Detection Loop with 50' Lead-In is an 18 AWG inductive loop, machine-wound and ready to seal into existing pavement. Wired to compatible automated system, the loop counts as one of the two means of entrapment protection UL 325 requires for gate operators, detecting the metal of any vehicle over the sensing area so the gate stops or reverses before contact. The install method is a 3/16" wide, 1" deep saw cut in the existing asphalt or concrete, with the loop laid in and sealed to finish the job. Its 28' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to industrial or municipal lots and large estate entrances.

Features:

• Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range
• Neatly stacked turns accept loop sealant completely, locking out moisture for long service life
• Optimizes read range, eliminates faulty signals, and minimizes callbacks
• Saves labor cost compared with winding a loop by hand in the field
• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures

Specifications:

• Loop type: Saw cut
• Total loop length: 68'
• Loop dimensions: 6' x 28'
• Lead-in length: 50'
• Slot size: 3/16" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 34'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes