Details

National Loop Co. 64' (6' X 26') Saw Cut Vehicle Detection Loop with 225' Lead-In for 32' Wide Driveways - X-NL32-18-225

Made for gate and access-control upgrades, the National Loop Co. 64' Saw Cut Vehicle Detection Loop with 225' Lead-In is an 18 AWG inductive loop, machine-wound and ready to seal into existing pavement. Working through a compatible loop detector, it detects the metal mass of vehicles above, satisfying the non-contact detection that UL 325 lists as one of its two required means of entrapment protection. Fitting takes one shallow saw cut: a 3/16" slot, 1" deep, cleaned out, filled with the loop, and sealed with loop sealant. With the 26' side crossing the lane and about 3' of clearance per edge, and the 6' side capturing vehicles in the direction of travel, the layout fits light industrial driveways and church or school lot entries.

Features:

• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations

Specifications:

• Loop type: Saw cut
• Total loop length: 64'
• Loop dimensions: 6' x 26'
• Lead-in length: 225'
• Slot size: 3/16" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 32'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes