Details

National Loop Co. 60' (6' X 24') Saw Cut Vehicle Detection Loop with 20' Lead-In for 30' Wide Driveways - X-NL30-18-20

A preformed 18 AWG inductive loop built for saw-cut installation, the National Loop Co. 60' Saw Cut Vehicle Detection Loop with 20' Lead-In detects vehicles passing over the driveway. Wired to compatible automated system, the loop counts as one of the two means of entrapment protection UL 325 requires for gate operators, detecting the metal of any vehicle over the sensing area so the gate stops or reverses before contact. Fitting takes one shallow saw cut: a 3/16" slot, 1" deep, cleaned out, filled with the loop, and sealed with loop sealant. With the 24' side crossing the lane and about 3' of clearance per edge, and the 6' side capturing vehicles in the direction of travel, the layout fits double-wide commercial entrances, equipment yards, and storage facilities.

Features:

• Saves labor cost compared with winding a loop by hand in the field
• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding

Specifications:

• Loop type: Saw cut
• Total loop length: 60'
• Loop dimensions: 6' x 24'
• Lead-in length: 20'
• Slot size: 3/16" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 30'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes