Details

National Loop Co. 56' (6' X 22') Saw Cut Vehicle Detection Loop with 75' Lead-In for 28' Wide Driveways - X-NL28-18-75

Made for gate and access-control upgrades, the National Loop Co. 56' Saw Cut Vehicle Detection Loop with 75' Lead-In is an 18 AWG inductive loop, machine-wound and ready to seal into existing pavement. Teamed with a loop detector, it gives the gate operator the presence detection UL 325 counts as one of its two means of entrapment protection, so the gate reverses or holds open while a vehicle sits in the path. Installers saw a 3/16" by 1" deep slot into the existing surface, drop the prewound loop in, and seal the slot against moisture. The 22' side covers the travel lane with roughly 3' of clearance on each side, and the 6' side reads vehicles as they roll through, making it a fit for apartment complex entrances and farm or agricultural property gates.

Features:

• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
• Wound from one continuous, non-spliced length of XLP-insulated wire, leaving no splice point between the loop and lead-in to fail

Specifications:

• Loop type: Saw cut
• Total loop length: 56'
• Loop dimensions: 6' x 22'
• Lead-in length: 75'
• Slot size: 3/16" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 28'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes