Details

National Loop Co. 56' (6' X 22') Saw Cut Vehicle Detection Loop with 200' Lead-In for 28' Wide Driveways - X-NL28-18-200

Designed to sense vehicles without any surface teardown, the National Loop Co. 56' Saw Cut Vehicle Detection Loop with 200' Lead-In is a preformed 18 AWG loop that drops into a saw-cut slot. Wired to compatible automated system, the loop counts as one of the two means of entrapment protection UL 325 requires for gate operators, detecting the metal of any vehicle over the sensing area so the gate stops or reverses before contact. The install method is a 3/16" wide, 1" deep saw cut in the existing asphalt or concrete, with the loop laid in and sealed to finish the job. With the 22' side crossing the lane and about 3' of clearance per edge, and the 6' side capturing vehicles in the direction of travel, the layout fits apartment complex entrances and farm or agricultural property gates.

Features:

• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
• Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
• Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range
• Neatly stacked turns accept loop sealant completely, locking out moisture for long service life

Specifications:

• Loop type: Saw cut
• Total loop length: 56'
• Loop dimensions: 6' x 22'
• Lead-in length: 200'
• Slot size: 3/16" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 28'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes