National Loop Co. 52' (6' X 20') Saw Cut Vehicle Detection Loop with 200' Lead-In for 26' Wide Driveways - X-NL26-18-200

National Loop Co. 52' (6' X 20') Saw Cut Vehicle Detection Loop with 200' Lead-In for 26' Wide Driveways - X-NL26-18-200

Monitoring the driveway around the clock, the National Loop Co. 52' Saw Cut Vehicle Detection Loop with 200' of lead-in to reach the detector covers the lane with dependable non-contact detection. It installs through a 1" deep saw cut in existing asphalt or concrete, so the finished surface stays largely intact. Formed as a 6' x 20' rectangle with 52' of perimeter, it matches the 26' drives found at light commercial entries and roomy 3-car residential drives.
Part Number: X-NL26-18-200
$277.91 each $277.91 each
OR
 

Details

National Loop Co. 52' (6' X 20') Saw Cut Vehicle Detection Loop with 200' Lead-In for 26' Wide Driveways - X-NL26-18-200

Wound from one continuous length of 18 AWG wire, the National Loop Co. 52' Saw Cut Vehicle Detection Loop with 200' Lead-In installs in an existing paved surface through a simple saw-cut slot. Once a loop detector reads its signal, the loop provides the non-contact vehicle detection automated gates rely on. Fitting takes one shallow saw cut: a 3/16" slot, 1" deep, cleaned out, filled with the loop, and sealed with loop sealant. With the 20' side crossing the lane and about 3' of clearance per edge, and the 6' side capturing vehicles in the direction of travel, the layout fits 3-car-wide residential drives and light commercial entries.

Features:

  • One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters

Specifications:

  • Loop type: Saw cut
  • Total loop length: 52'
  • Loop dimensions: 6' x 20'
  • Lead-in length: 200'
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 26'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL26-18-200?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 200'
Loop Length Size 6' X 20'
Total Loop Length 52'
Wire Size 3/16"
SKU X-NL26-18-200
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file