National Loop Co. 50' (6' X 19') Saw Cut Vehicle Detection Loop with 200' Lead-In for 25' Wide Driveways - X-NL25-18-200

National Loop Co. 50' (6' X 19') Saw Cut Vehicle Detection Loop with 200' Lead-In for 25' Wide Driveways - X-NL25-18-200

Rain, snow, and darkness never interrupt the wire, and the National Loop Co. 50' Saw Cut Vehicle Detection Loop with 200' of lead-in wire monitors the drive for traffic of any size. Crews cut a narrow channel in the finished pavement, set the preformed wire inside, and seal it against moisture. Total wire runs 50' in a 6' x 19' pattern made for 25' wide driveways, including estate properties, horse farms, and private road entrances.
Part Number: X-NL25-18-200
$274.20 each $274.20 each
OR
 

Details

National Loop Co. 50' (6' X 19') Saw Cut Vehicle Detection Loop with 200' Lead-In for 25' Wide Driveways - X-NL25-18-200

Made for gate and access-control upgrades, the National Loop Co. 50' Saw Cut Vehicle Detection Loop with 200' Lead-In is an 18 AWG inductive loop, machine-wound and ready to seal into existing pavement. Paired with a compatible loop detector, it senses the metal mass of a passing car or truck and signals the gate operator to open, hold, or reverse. Installation calls for sawing a 3/16" slot 1" deep into existing asphalt or concrete, laying the loop in the slot, and sealing it, with no hand-winding or turn counting required. Its 19' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to estate properties, horse farms, and private road entrances.

Features:

  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
  • Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
  • Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range

Specifications:

  • Loop type: Saw cut
  • Total loop length: 50'
  • Loop dimensions: 6' x 19'
  • Lead-in length: 200'
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 25'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL25-18-200?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 200'
Loop Length Size 6' X 19'
Total Loop Length 50'
Wire Size 3/16"
SKU X-NL25-18-200
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file