National Loop Co. 48' (6' X 18') Saw Cut Vehicle Detection Loop with 200' Lead-In for 24' Wide Driveways - X-NL24-18-200

National Loop Co. 48' (6' X 18') Saw Cut Vehicle Detection Loop with 200' Lead-In for 24' Wide Driveways - X-NL24-18-200

The National Loop Co. 48' Saw Cut Vehicle Detection Loop with 200' Lead-In sends a signal to the gate controller whenever a car or truck crosses its wire. Crews cut a narrow channel in the existing driveway, set the factory-wound loop inside, and seal it against moisture. With 48' of 18 AWG wire laid out 6' x 18', it matches 24' wide driveways, including church lots, small office entries, and 2-car-plus-walkway drives, and its 200' lead-in reaches control boxes mounted far from the loop.
Part Number: X-NL24-18-200
$270.50 each $270.50 each
OR
 

Details

National Loop Co. 48' (6' X 18') Saw Cut Vehicle Detection Loop with 200' Lead-In for 24' Wide Driveways - X-NL24-18-200

Contractors reach for the National Loop Co. 48' Saw Cut Vehicle Detection Loop with 200' Lead-In when an existing asphalt or concrete drive needs reliable vehicle detection. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator dependable non-contact detection. Installers saw a 3/16" by 1" deep slot into the existing surface, drop the prewound loop in, and seal the slot against moisture. With the 18' side crossing the lane and about 3' of clearance per edge, and the 6' side capturing vehicles in the direction of travel, the layout fits 2-car plus full walkway and church or small office lot entries.

Features:

  • Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
  • One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations

Specifications:

  • Loop type: Saw cut
  • Total loop length: 48'
  • Loop dimensions: 6' x 18'
  • Lead-in length: 200'
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 24'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL24-18-200?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 200'
Loop Length Size 6' X 18'
Total Loop Length 48'
Wire Size 3/16"
SKU X-NL24-18-200
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file