Details

National Loop Co. 48' (6' X 18') Saw Cut Vehicle Detection Loop with 175' Lead-In for 24' Wide Driveways - X-NL24-18-175

The National Loop Co. 48' Saw Cut Vehicle Detection Loop with 175' Lead-In is a preformed 18 AWG inductive vehicle detection loop that arrives ready to drop into a saw-cut slot. Wired to compatible automated system, the loop counts as one of the two means of entrapment protection UL 325 requires for gate operators, detecting the metal of any vehicle over the sensing area so the gate stops or reverses before contact. Setup is a 3-step process: saw a 3/16" slot 1" deep in the pavement, press the loop in, and seal over it. With the 18' side crossing the lane and about 3' of clearance per edge, and the 6' side capturing vehicles in the direction of travel, the layout fits 2-car plus full walkway and church or small office lot entries.

Features:

• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
• Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail

Specifications:

• Loop type: Saw cut
• Total loop length: 48'
• Loop dimensions: 6' x 18'
• Lead-in length: 175'
• Slot size: 3/16" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 24'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes