National Loop Co. 48' (6' X 18') Saw Cut Vehicle Detection Loop with 100' Lead-In for 24' Wide Driveways - X-NL24-18-100

National Loop Co. 48' (6' X 18') Saw Cut Vehicle Detection Loop with 100' Lead-In for 24' Wide Driveways - X-NL24-18-100

Monitoring the driveway around the clock, the National Loop Co. 48' Saw Cut Vehicle Detection Loop with its 100' lead-in helps automatic gates sense traffic without any physical contact. The wire lays into a slot cut about 1" deep in the asphalt or concrete, then the opening gets sealed. The 48' loop wraps into a 6' x 18' rectangle that fits 24' wide drives, including church lots, small office entries, and 2-car-plus-walkway drives.
Part Number: X-NL24-18-100
$205.17 each $205.17 each
OR
 

Details

National Loop Co. 48' (6' X 18') Saw Cut Vehicle Detection Loop with 100' Lead-In for 24' Wide Driveways - X-NL24-18-100

Built for retrofitting an existing paved driveway, the National Loop Co. 48' Saw Cut Vehicle Detection Loop with 100' Lead-In is a factory-wound 18 AWG inductive loop ready to lay into a saw-cut slot. Paired with a compatible loop detector, it senses the metal mass of a passing car or truck and signals the gate operator to open, hold, or reverse. Fitting takes one shallow saw cut: a 3/16" slot, 1" deep, cleaned out, filled with the loop, and sealed with loop sealant. Its 18' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to 2-car plus full walkway and church or small office lot entries.

Features:

  • Neatly stacked turns accept loop sealant completely, locking out moisture for long service life
  • Optimizes read range, eliminates faulty signals, and minimizes callbacks
  • Saves labor cost compared with winding a loop by hand in the field
  • Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
  • One continuous, non-spliced XLP-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment

Specifications:

  • Loop type: Saw cut
  • Total loop length: 48'
  • Loop dimensions: 6' x 18'
  • Lead-in length: 100'
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 24'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL24-18-100?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 100'
Loop Length Size 6' X 18'
Total Loop Length 48'
Wire Size 3/16"
SKU X-NL24-18-100
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file