Details

National Loop Co. 44' (6' X 16') Saw Cut Vehicle Detection Loop with 175' Lead-In for 22' Wide Driveways - X-NL22-18-175

A preformed 18 AWG inductive loop built for saw-cut installation, the National Loop Co. 44' Saw Cut Vehicle Detection Loop with 175' Lead-In detects vehicles passing over the driveway. Once a loop detector reads its signal, the loop covers the non-contact vehicle detection that UL 325 requires as one of the two means of entrapment protection for automated gates. Fitting takes one shallow saw cut: a 3/16" slot, 1" deep, cleaned out, filled with the loop, and sealed with loop sealant. Its 16' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to estate homes and small HOA or church parking lot entries.

Features:

• Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
• Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range
• Neatly stacked turns accept loop sealant completely, locking out moisture for long service life
• Optimizes read range, eliminates faulty signals, and minimizes callbacks
• Saves labor cost compared with winding a loop by hand in the field
• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters

Specifications:

• Loop type: Saw cut
• Total loop length: 44'
• Loop dimensions: 6' x 16'
• Lead-in length: 175'
• Slot size: 3/16" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 22'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes