Details

National Loop Co. 42' (6' X 15') Saw Cut Vehicle Detection Loop with 100' Lead-In for 21' Wide Driveways - X-NL21-18-100

Built for retrofitting an existing paved driveway, the National Loop Co. 42' Saw Cut Vehicle Detection Loop with 100' Lead-In is a factory-wound 18 AWG inductive loop ready to lay into a saw-cut slot. Wired to compatible automated system, the loop counts as one of the two means of entrapment protection UL 325 requires for gate operators, detecting the metal of any vehicle over the sensing area so the gate stops or reverses before contact. Fitting takes one shallow saw cut: a 3/16" slot, 1" deep, cleaned out, filled with the loop, and sealed with loop sealant. Its 15' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to 2-car plus guest parking and wider rural/farm gate entrances.

Features:

• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
• Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
• Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range
• Neatly stacked turns accept loop sealant completely, locking out moisture for long service life
• Optimizes read range, eliminates faulty signals, and minimizes callbacks

Specifications:

• Loop type: Saw cut
• Total loop length: 42'
• Loop dimensions: 6' x 15'
• Lead-in length: 100'
• Slot size: 3/16" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 21'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes