Details

National Loop Co. 40' (6' X 14') Saw Cut Vehicle Detection Loop with 150' Lead-In for 20' Wide Driveways - X-NL20-18-150

Made for gate and access-control upgrades, the National Loop Co. 40' Saw Cut Vehicle Detection Loop with 150' Lead-In is an 18 AWG inductive loop, machine-wound and ready to seal into existing pavement. Once a loop detector reads its signal, the loop covers the non-contact vehicle detection that UL 325 requires as one of the two means of entrapment protection for automated gates. Fitting takes one shallow saw cut: a 3/16" slot, 1" deep, cleaned out, filled with the loop, and sealed with loop sealant. Its 14' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to ranch entrances, farm properties, and estate homes with dual swing gates.

Features:

• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations

Specifications:

• Loop type: Saw cut
• Total loop length: 40'
• Loop dimensions: 6' x 14'
• Lead-in length: 150'
• Slot size: 3/16" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 20'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes