National Loop Co. 36' (6' X 12') Saw Cut Vehicle Detection Loop with 200' Lead-In for 18' Wide Driveways - X-NL18-18-200

National Loop Co. 36' (6' X 12') Saw Cut Vehicle Detection Loop with 200' Lead-In for 18' Wide Driveways - X-NL18-18-200

The National Loop Co. 36' Saw Cut Vehicle Detection Loop with its 200' lead-in feels the metal of a passing vehicle through the surface. Fitting it takes a concrete saw, a 1" slot in the driveway surface, and a bead of sealant over the top. Its footprint of 6' x 12' yields 36' of wire, a fit for 18' wide driveways including small commercial entries and generous 2-car drives.
Part Number: X-NL18-18-200
$248.27 each $248.27 each
OR
 

Details

National Loop Co. 36' (6' X 12') Saw Cut Vehicle Detection Loop with 200' Lead-In for 18' Wide Driveways - X-NL18-18-200

Sized to match a specific driveway width, the National Loop Co. 36' Saw Cut Vehicle Detection Loop with 200' Lead-In is a factory-wound 18 AWG loop for retrofit installations. Paired with a compatible loop detector, it senses the metal mass of a passing car or truck and signals the gate operator to open, hold, or reverse. Setup is a 3-step process: saw a 3/16" slot 1" deep in the pavement, press the loop in, and seal over it. Its 12' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to roomy 2-car driveways and small commercial entries.

Features:

  • Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
  • One continuous, non-spliced XLP-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations

Specifications:

  • Loop type: Saw cut
  • Total loop length: 36'
  • Loop dimensions: 6' x 12'
  • Lead-in length: 200'
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 18'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL18-18-200?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 200'
Loop Length Size 6' X 12'
Total Loop Length 36'
Wire Size 3/16"
SKU X-NL18-18-200
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file