National Loop Co. 34' (5' X 12') Saw Cut Vehicle Detection Loop with 250' Lead-In for 17' Wide Driveways - X-NL17-18-250

National Loop Co. 34' (5' X 12') Saw Cut Vehicle Detection Loop with 250' Lead-In for 17' Wide Driveways - X-NL17-18-250

With traffic flowing in and out all day, the National Loop Co. 34' Saw Cut Vehicle Detection Loop with 250' of lead-in to reach the detector spots cars and trucks without any physical contact. Installation calls for a 1" deep slot saw cut into the existing asphalt or concrete, with the loop pressed in and the cut sealed. Its 34' of wire forms a 5' x 12' rectangle sized for 17' wide driveways at homes with boat or trailer parking and newer subdivision drives.
Part Number: X-NL17-18-250
$270.04 each $270.04 each
OR

Details

National Loop Co. 34' (5' X 12') Saw Cut Vehicle Detection Loop with 250' Lead-In for 17' Wide Driveways - X-NL17-18-250

Made for gate and access-control upgrades, the National Loop Co. 34' Saw Cut Vehicle Detection Loop with 250' Lead-In is an 18 AWG inductive loop, machine-wound and ready to seal into existing pavement. Paired with a compatible loop detector, it senses the metal mass of a passing car or truck and signals the gate operator to open, hold, or reverse. Setup is a 3-step process: saw a 3/16" slot 1" deep in the pavement, press the loop in, and seal over it. With the 12' side crossing the lane and about 2' 6" of clearance per edge, and the 5' side capturing vehicles in the direction of travel, the layout fits 2-car drives in newer subdivisions and homes with boat or trailer parking.

Features:

  • One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters

Specifications:

  • Loop type: Saw cut
  • Total loop length: 34'
  • Loop dimensions: 5' x 12'
  • Lead-in length: 250'
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 17'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL17-18-250?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 250'
Loop Length Size 5' X 12'
Total Loop Length 34'
Wire Size 3/16"
SKU X-NL17-18-250
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file