National Loop Co. 34' (5' X 12') Saw Cut Vehicle Detection Loop with 225' Lead-In for 17' Wide Driveways - X-NL17-18-225

National Loop Co. 34' (5' X 12') Saw Cut Vehicle Detection Loop with 225' Lead-In for 17' Wide Driveways - X-NL17-18-225

Day or night, the National Loop Co. 34' Saw Cut Vehicle Detection Loop with 225' of lead-in to reach the detector spots cars and trucks without any physical contact. Crews cut a narrow channel in the finished pavement, set the preformed wire inside, and seal it against moisture. Total wire runs 34' in a 5' x 12' pattern made for 17' wide driveways, including homes with boat or trailer parking and newer subdivision drives.
Part Number: X-NL17-18-225
$257.30 each $257.30 each
OR
 

Details

National Loop Co. 34' (5' X 12') Saw Cut Vehicle Detection Loop with 225' Lead-In for 17' Wide Driveways - X-NL17-18-225

Because it arrives prewound and precut, the National Loop Co. 34' Saw Cut Vehicle Detection Loop with 225' Lead-In takes the guesswork out of adding vehicle detection to an existing driveway. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator dependable non-contact detection. The install method is a 3/16" wide, 1" deep saw cut in the existing asphalt or concrete, with the loop laid in and sealed to finish the job. Its 12' side spans the travel lane while the 5' side runs in the direction of traffic, leaving roughly 2' 6" of clearance on each edge, an arrangement well suited to 2-car drives in newer subdivisions and homes with boat or trailer parking.

Features:

  • One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters

Specifications:

  • Loop type: Saw cut
  • Total loop length: 34'
  • Loop dimensions: 5' x 12'
  • Lead-in length: 225'
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 17'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL17-18-225?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 225'
Loop Length Size 5' X 12'
Total Loop Length 34'
Wire Size 3/16"
SKU X-NL17-18-225
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file