National Loop Co. 32' (4' X 12') Saw Cut Vehicle Detection Loop with 100' Lead-In for 16' Wide Driveways - X-NL16-18-100

National Loop Co. 32' (4' X 12') Saw Cut Vehicle Detection Loop with 100' Lead-In for 16' Wide Driveways - X-NL16-18-100

Day or night, the National Loop Co. 32' Saw Cut Vehicle Detection Loop with 100' of lead-in wire catches every vehicle that crosses its rectangle. The wire lays into a slot cut about 1" deep in the asphalt or concrete, then the opening gets sealed. The 32' loop wraps into a 4' x 12' rectangle that fits 16' wide drives, including common 2-car suburban driveways and small apartment building lots.
Part Number: X-NL16-18-100
$175.51 each $175.51 each
OR
 

Details

National Loop Co. 32' (4' X 12') Saw Cut Vehicle Detection Loop with 100' Lead-In for 16' Wide Driveways - X-NL16-18-100

A preformed 18 AWG inductive loop built for saw-cut installation, the National Loop Co. 32' Saw Cut Vehicle Detection Loop with 100' Lead-In detects vehicles passing over the driveway. Once a loop detector reads its signal, the loop provides the non-contact vehicle detection automated gates rely on. Installation calls for sawing a 3/16" slot 1" deep into existing asphalt or concrete, laying the loop in the slot, and sealing it, with no hand-winding or turn counting required. Its 12' side spans the travel lane while the 4' side runs in the direction of traffic, leaving roughly 2' of clearance on each edge, an arrangement well suited to common 2-car suburban driveways and small apartment building lots.

Features:

  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
  • Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail

Specifications:

  • Loop type: Saw cut
  • Total loop length: 32'
  • Loop dimensions: 4' x 12'
  • Lead-in length: 100'
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 16'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL16-18-100?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 100'
Loop Length Size 4' X 12'
Total Loop Length 32'
Wire Size 3/16"
SKU X-NL16-18-100
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file