Details

National Loop Co. 30' (4' X 11') Saw Cut Vehicle Detection Loop with 250' Lead-In for 15' Wide Driveways - X-NL15-18-250

Because it arrives prewound and precut, the National Loop Co. 30' Saw Cut Vehicle Detection Loop with 250' Lead-In takes the guesswork out of adding vehicle detection to an existing driveway. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator the non-contact detection that fills one of the two UL 325 entrapment protection slots. Setup is a 3-step process: saw a 3/16" slot 1" deep in the pavement, press the loop in, and seal over it. Its 11' side spans the travel lane while the 4' side runs in the direction of traffic, leaving roughly 2' of clearance on each edge, an arrangement well suited to standard 2-car driveways on modest suburban lots.

Features:

• Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range
• Neatly stacked turns accept loop sealant completely, locking out moisture for long service life
• Optimizes read range, eliminates faulty signals, and minimizes callbacks
• Saves labor cost compared with winding a loop by hand in the field
• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures

Specifications:

• Loop type: Saw cut
• Total loop length: 30'
• Loop dimensions: 4' x 11'
• Lead-in length: 250'
• Slot size: 3/16" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 15'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes