National Loop Co. 30' (4' X 11') Saw Cut Vehicle Detection Loop with 175' Lead-In for 15' Wide Driveways - X-NL15-18-175

National Loop Co. 30' (4' X 11') Saw Cut Vehicle Detection Loop with 175' Lead-In for 15' Wide Driveways - X-NL15-18-175

Behind every loop detector sits a coil of wire, and the National Loop Co. 30' Saw Cut Vehicle Detection Loop with a 175' lead-in senses the metal of any car or truck that crosses it. You saw a thin slot in the existing drive, drop the loop in, and seal it, with no demolition required. The 4' x 11' rectangle carries 30' of detection wire, sized to 15' wide driveways at standard 2-car driveways on modest suburban lots.
Part Number: X-NL15-18-175
$224.40 each $224.40 each
OR

Details

National Loop Co. 30' (4' X 11') Saw Cut Vehicle Detection Loop with 175' Lead-In for 15' Wide Driveways - X-NL15-18-175

The National Loop Co. 30' Saw Cut Vehicle Detection Loop with 175' Lead-In is a preformed 18 AWG inductive vehicle detection loop that arrives ready to drop into a saw-cut slot. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator dependable non-contact detection. Setup is a 3-step process: saw a 3/16" slot 1" deep in the pavement, press the loop in, and seal over it. With the 11' side crossing the lane and about 2' of clearance per edge, and the 4' side capturing vehicles in the direction of travel, the layout fits standard 2-car driveways on modest suburban lots.

Features:

  • Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
  • One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations

Specifications:

  • Loop type: Saw cut
  • Total loop length: 30'
  • Loop dimensions: 4' x 11'
  • Lead-in length: 175'
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 15'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL15-18-175?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 175'
Loop Length Size 4' X 11'
Total Loop Length 30'
Wire Size 3/16"
SKU X-NL15-18-175
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file