National Loop Co. 28' (4' X 10') Saw Cut Vehicle Detection Loop with 100' Lead-In for 14' Wide Driveways - X-NL14-18-100

National Loop Co. 28' (4' X 10') Saw Cut Vehicle Detection Loop with 100' Lead-In for 14' Wide Driveways - X-NL14-18-100

Behind every loop detector sits a coil of wire, and the National Loop Co. 28' Saw Cut Vehicle Detection Loop with 100' of lead-in wire monitors the drive for traffic of any size, provides the non-contact detection that fills one of the two means of entrapment protection required by UL 325. It installs through a 1" deep saw cut in existing asphalt or concrete, so the finished surface stays largely intact. Formed as a 4' x 10' rectangle with 28' of perimeter, it matches the 14' drives found at wide single-car or tight 2-car driveways and long rural drives.
Part Number: X-NL14-18-100
$168.10 each $168.10 each
OR

Details

National Loop Co. 28' (4' X 10') Saw Cut Vehicle Detection Loop with 100' Lead-In for 14' Wide Driveways - X-NL14-18-100

Gate installers can turn an existing driveway into part of the safety system with the National Loop Co. 28' Saw Cut Vehicle Detection Loop with 100' Lead-In, a preformed 18 AWG inductive loop. Once a loop detector reads its signal, the loop covers the non-contact vehicle detection that UL 325 requires as one of the two means of entrapment protection for automated gates. Setup is a 3-step process: saw a 3/16" slot 1" deep in the pavement, press the loop in, and seal over it. Its 10' side spans the travel lane while the 4' side runs in the direction of traffic, leaving roughly 2' of clearance on each edge, an arrangement well suited to wide single-car or tight 2-car driveways and long rural drives.

Features:

  • Optimizes read range, eliminates faulty signals, and minimizes callbacks
  • Saves labor cost compared with winding a loop by hand in the field
  • Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
  • Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
  • One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection

Specifications:

  • Loop type: Saw cut
  • Total loop length: 28'
  • Loop dimensions: 4' x 10'
  • Lead-in length: 100'
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 14'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL14-18-100?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 100'
Loop Length Size 4' X 10'
Total Loop Length 28'
Wire Size 3/16"
SKU X-NL14-18-100
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file