Details

National Loop Co. 26' (4' X 9') Saw Cut Vehicle Detection Loop with 200' Lead-In for 13' Wide Driveways - X-NL13-18-200

Gate installers can turn an existing driveway into part of the safety system with the National Loop Co. 26' Saw Cut Vehicle Detection Loop with 200' Lead-In, a preformed 18 AWG inductive loop. Paired with a compatible loop detector, it senses the metal mass of a passing car or truck and signals the gate operator to open, hold, or reverse, providing one of the two means of entrapment protection UL 325 requires for automated gates. Fitting takes one shallow saw cut: a 3/16" slot, 1" deep, cleaned out, filled with the loop, and sealed with loop sealant. Its 9' side spans the travel lane while the 4' side runs in the direction of traffic, leaving roughly 2' of clearance on each edge, an arrangement well suited to single-car driveways with a walkway beside them and rural homes with truck access.

Features:

• Optimizes read range, eliminates faulty signals, and minimizes callbacks
• Saves labor cost compared with winding a loop by hand in the field
• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection

Specifications:

• Loop type: Saw cut
• Total loop length: 26'
• Loop dimensions: 4' x 9'
• Lead-in length: 200'
• Slot size: 3/16" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 13'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes