Details

National Loop Co. 24' (4' X 8') Saw Cut Vehicle Detection Loop with 75' Lead-In for 12' Wide Driveways - X-NL12-18-75

Because it arrives prewound and precut, the National Loop Co. 24' Saw Cut Vehicle Detection Loop with 75' Lead-In takes the guesswork out of adding vehicle detection to an existing driveway. Teamed with a loop detector, it gives the gate operator the presence detection UL 325 counts as one of its two means of entrapment protection, so the gate reverses or holds open while a vehicle sits in the path. Installers saw a 3/16" by 1" deep slot into the existing surface, drop the prewound loop in, and seal the slot against moisture. With the 8' side crossing the lane and about 2' of clearance per edge, and the 4' side capturing vehicles in the direction of travel, the layout fits comfortable single-car driveways, newer suburban builds, and small business side lots.

Features:

• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
• Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
• Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range

Specifications:

• Loop type: Saw cut
• Total loop length: 24'
• Loop dimensions: 4' x 8'
• Lead-in length: 75'
• Slot size: 3/16" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 12'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes