National Loop Co. 24' (4' X 8') Saw Cut Vehicle Detection Loop with 50' Lead-In for 12' Wide Driveways - X-NL12-18-50

National Loop Co. 24' (4' X 8') Saw Cut Vehicle Detection Loop with 50' Lead-In for 12' Wide Driveways - X-NL12-18-50

Sensing traffic through the pavement itself, the National Loop Co. 24' Saw Cut Vehicle Detection Loop with a 50' lead-in provides the non-contact vehicle detection. No repaving is needed, because the loop lays into a slim saw cut and seals flush with the surface. Its 4' x 8' shape adds up to 24' of wire, the right footprint for 12' wide driveways including comfortable single-car driveways and newer suburban builds.
Part Number: X-NL12-18-50
$138.36 each $138.36 each
OR
 

Details

National Loop Co. 24' (4' X 8') Saw Cut Vehicle Detection Loop with 50' Lead-In for 12' Wide Driveways - X-NL12-18-50

Sized to match a specific driveway width, the National Loop Co. 24' Saw Cut Vehicle Detection Loop with 50' Lead-In is a factory-wound 18 AWG loop for retrofit installations. Teamed with a loop detector, it gives the gate operator the presence detection it needs, so the gate reverses or holds open while a vehicle sits in the path. Setup is a 3-step process: saw a 3/16" slot 1" deep in the pavement, press the loop in, and seal over it. Its 8' side spans the travel lane while the 4' side runs in the direction of traffic, leaving roughly 2' of clearance on each edge, an arrangement well suited to comfortable single-car driveways, newer suburban builds, and small business side lots.

Features:

  • One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters

Specifications:

  • Loop type: Saw cut
  • Total loop length: 24'
  • Loop dimensions: 4' x 8'
  • Lead-in length: 50'
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 12'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL12-18-50?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 50'
Loop Length Size 4' X 8'
Total Loop Length 24'
Wire Size 3/16"
SKU X-NL12-18-50
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file