National Loop Co. 22' (4' X 7') Saw Cut Vehicle Detection Loop with 30' Lead-In for 11' Wide Driveways - X-NL11-18-30

National Loop Co. 22' (4' X 7') Saw Cut Vehicle Detection Loop with 30' Lead-In for 11' Wide Driveways - X-NL11-18-30

The National Loop Co. 22' Saw Cut Vehicle Detection Loop with 30' Lead-In turns passing traffic into gate commands, opening for cars and trucks without a keypad or remote. Wired to a compatible loop detector, it keeps the gate from closing on a waiting vehicle. Crews cut a narrow channel in the existing driveway, set the factory-wound loop inside, and seal it against moisture. Total wire runs 22' in a 4' x 7' layout, with 18 AWG conductors sized to 11' wide driveways at older neighborhoods with roomier single-car drives.
Part Number: X-NL11-18-30
$125.75 each $125.75 each
OR

Details

National Loop Co. 22' (4' X 7') Saw Cut Vehicle Detection Loop with 30' Lead-In for 11' Wide Driveways - X-NL11-18-30

Gate installers can turn an existing driveway into part of the safety system with the National Loop Co. 22' Saw Cut Vehicle Detection Loop with 30' Lead-In, a preformed 18 AWG inductive loop. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator dependable non-contact detection. Fitting takes one shallow saw cut: a 3/16" slot, 1" deep, cleaned out, filled with the loop, and sealed with loop sealant. With the 7' side crossing the lane and about 2' of clearance per edge, and the 4' side capturing vehicles in the direction of travel, the layout fits slightly wider suburban single-car drives and older neighborhoods with wider lot cuts.

Features:

  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
  • Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
  • Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range

Specifications:

  • Loop type: Saw cut
  • Total loop length: 22'
  • Loop dimensions: 4' x 7'
  • Lead-in length: 30'
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 11'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL11-18-30?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 30'
Loop Length Size 4' X 7'
Total Loop Length 22'
Wire Size 3/16"
SKU X-NL11-18-30
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file