National Loop Co. 22' (4' X 7') Saw Cut Vehicle Detection Loop with 20' Lead-In for 11' Wide Driveways - X-NL11-18-20

National Loop Co. 22' (4' X 7') Saw Cut Vehicle Detection Loop with 20' Lead-In for 11' Wide Driveways - X-NL11-18-20

The National Loop Co. 22' Saw Cut Vehicle Detection Loop with 20' Lead-In detects arriving vehicles and signals a compatible loop detector to open the gate. It sees the vehicle without touching it. Crews cut a narrow channel in the existing driveway, set the factory-wound loop inside, and seal it against moisture. The 4' x 7' rectangle of 18 AWG wire gives 22' of detection coverage, a fit for 11' wide driveways such as older neighborhoods with roomier single-car drives.
Part Number: X-NL11-18-20
$121.34 each $121.34 each
OR
 

Details

National Loop Co. 22' (4' X 7') Saw Cut Vehicle Detection Loop with 20' Lead-In for 11' Wide Driveways - X-NL11-18-20

The National Loop Co. 22' Saw Cut Vehicle Detection Loop with 20' Lead-In is a preformed 18 AWG inductive vehicle detection loop that arrives ready to drop into a saw-cut slot. Working through a compatible loop detector, it detects the metal mass of vehicles above. Fitting takes one shallow saw cut: a 3/16" slot, 1" deep, cleaned out, filled with the loop, and sealed with loop sealant. With the 7' side crossing the lane and about 2' of clearance per edge, and the 4' side capturing vehicles in the direction of travel, the layout fits slightly wider suburban single-car drives and older neighborhoods with wider lot cuts.

Features:

  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
  • Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail

Specifications:

  • Loop type: Saw cut
  • Total loop length: 22'
  • Loop dimensions: 4' x 7'
  • Lead-in length: 20'
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 11'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL11-18-20?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 20'
Loop Length Size 4' X 7'
Total Loop Length 22'
Wire Size 3/16"
SKU X-NL11-18-20
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file