Details

National Loop Co. 20' (4' X 6') Saw Cut Vehicle Detection Loop with 30' Lead-In for 10' Wide Driveways - X-NL10-18-30

Because it arrives prewound and precut, the National Loop Co. 20' Saw Cut Vehicle Detection Loop with 30' Lead-In takes the guesswork out of adding vehicle detection to an existing driveway. Teamed with a loop detector, it gives the gate operator the presence detection UL 325 counts as one of its two means of entrapment protection, so the gate reverses or holds open while a vehicle sits in the path. Installation calls for sawing a 3/16" slot 1" deep into existing asphalt or concrete, laying the loop in the slot, and sealing it, with no hand-winding or turn counting required. With the 6' side crossing the lane and about 2' of clearance per edge, and the 4' side capturing vehicles in the direction of travel, the layout fits standard single-car suburban homes, duplex driveways, and small farm entrances.

Features:

• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations

Specifications:

• Loop type: Saw cut
• Total loop length: 20'
• Loop dimensions: 4' x 6'
• Lead-in length: 30'
• Slot size: 3/16" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 10'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes