National Loop Co. 18' (3' X 6') Saw Cut Vehicle Detection Loop with 250' Lead-In for 9' Wide Driveways - X-NL09-18-250

National Loop Co. 18' (3' X 6') Saw Cut Vehicle Detection Loop with 250' Lead-In for 9' Wide Driveways - X-NL09-18-250

Keeping an automatic gate both safe and convenient, the National Loop Co. 18' Saw Cut Vehicle Detection Loop with 250' of lead-in wire monitors the drive for traffic of any size. Installation calls for a 1" deep slot saw cut into the existing asphalt or concrete, with the loop pressed in and the cut sealed. Its 18' of wire forms a 3' x 6' rectangle sized for 9' wide driveways at suburban single-car driveways and condo or townhome parking pads.
Part Number: X-NL09-18-250
$236.68 each $236.68 each
OR
 

Details

National Loop Co. 18' (3' X 6') Saw Cut Vehicle Detection Loop with 250' Lead-In for 9' Wide Driveways - X-NL09-18-250

Made for gate and access-control upgrades, the National Loop Co. 18' Saw Cut Vehicle Detection Loop with 250' Lead-In is an 18 AWG inductive loop, machine-wound and ready to seal into existing pavement. Teamed with a loop detector, it gives the gate operator the presence detection it needs, so the gate reverses or holds open while a vehicle sits in the path. Fitting takes one shallow saw cut: a 3/16" slot, 1" deep, cleaned out, filled with the loop, and sealed with loop sealant. Its 6' side spans the travel lane while the 3' side runs in the direction of traffic, leaving roughly 1' 6" of clearance on each edge, an arrangement well suited to suburban single-car driveways, condo/townhome parking pads, and small ranch homes.

Features:

  • One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters

Specifications:

  • Loop type: Saw cut
  • Total loop length: 18'
  • Loop dimensions: 3' x 6'
  • Lead-in length: 250'
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 9'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL09-18-250?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 250'
Loop Length Size 3' X 6'
Total Loop Length 18'
Wire Size 3/16"
SKU X-NL09-18-250
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file