National Loop Co. 18' (3' X 6') Saw Cut Vehicle Detection Loop with 20' Lead-In for 9' Wide Driveways - X-NL09-18-20

National Loop Co. 18' (3' X 6') Saw Cut Vehicle Detection Loop with 20' Lead-In for 9' Wide Driveways - X-NL09-18-20

Rain, snow, and darkness never interrupt the wire, and the National Loop Co. 18' Saw Cut Vehicle Detection Loop with 20' of lead-in wire catches every vehicle that crosses its rectangle. Installation calls for a 1" deep slot saw cut into the existing asphalt or concrete, with the loop pressed in and the cut sealed. Its 18' of wire forms a 3' x 6' rectangle sized for 9' wide driveways at suburban single-car driveways and condo or townhome parking pads.
Part Number: X-NL09-18-20
$110.19 each $110.19 each
OR

Details

National Loop Co. 18' (3' X 6') Saw Cut Vehicle Detection Loop with 20' Lead-In for 9' Wide Driveways - X-NL09-18-20

Sized to match a specific driveway width, the National Loop Co. 18' Saw Cut Vehicle Detection Loop with 20' Lead-In is a factory-wound 18 AWG loop for retrofit installations. Working through a compatible loop detector, it detects the metal mass of vehicles above. Setup is a 3-step process: saw a 3/16" slot 1" deep in the pavement, press the loop in, and seal over it. With the 6' side crossing the lane and about 1' 6" of clearance per edge, and the 3' side capturing vehicles in the direction of travel, the layout fits suburban single-car driveways, condo/townhome parking pads, and small ranch homes.

Features:

  • Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
  • One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations

Specifications:

  • Loop type: Saw cut
  • Total loop length: 18'
  • Loop dimensions: 3' x 6'
  • Lead-in length: 20'
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 9'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL09-18-20?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 20'
Loop Length Size 3' X 6'
Total Loop Length 18'
Wire Size 3/16"
SKU X-NL09-18-20
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file