National Loop Co. 18' (3' X 6') Saw Cut Vehicle Detection Loop with 100' Lead-In for 9' Wide Driveways - X-NL09-18-100

National Loop Co. 18' (3' X 6') Saw Cut Vehicle Detection Loop with 100' Lead-In for 9' Wide Driveways - X-NL09-18-100

Sensing traffic through the pavement itself, the National Loop Co. 18' Saw Cut Vehicle Detection Loop with 100' of lead-in wire fills one of the two entrapment protection roles UL 325 assigns to gate systems. Because it arrives preformed, it goes straight into a 1" saw-cut groove without any winding on site. At 18' of total loop length, the 3' x 6' layout fits 9' wide driveways, from suburban single-car driveways and condo or townhome parking pads.
Part Number: X-NL09-18-100
$145.87 each $145.87 each
OR

Details

National Loop Co. 18' (3' X 6') Saw Cut Vehicle Detection Loop with 100' Lead-In for 9' Wide Driveways - X-NL09-18-100

Installing the National Loop Co. 18' Saw Cut Vehicle Detection Loop with 100' Lead-In means sawing one slot, laying in a preformed 18 AWG loop, and sealing it. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator the non-contact detection that fills one of the two UL 325 entrapment protection slots. The install method is a 3/16" wide, 1" deep saw cut in the existing asphalt or concrete, with the loop laid in and sealed to finish the job. Its 6' side spans the travel lane while the 3' side runs in the direction of traffic, leaving roughly 1' 6" of clearance on each edge, an arrangement well suited to suburban single-car driveways, condo/townhome parking pads, and small ranch homes.

Features:

  • Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
  • One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system

Specifications:

  • Loop type: Saw cut
  • Total loop length: 18'
  • Loop dimensions: 3' x 6'
  • Lead-in length: 100'
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 9'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL09-18-100?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 100'
Loop Length Size 3' X 6'
Total Loop Length 18'
Wire Size 3/16"
SKU X-NL09-18-100
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file