National Loop Co. 16' (2' X 6') Saw Cut Vehicle Detection Loop with 20' Lead-In for 8' Wide Driveways - X-NL08-18-20

National Loop Co. 16' (2' X 6') Saw Cut Vehicle Detection Loop with 20' Lead-In for 8' Wide Driveways - X-NL08-18-20

Monitoring the driveway around the clock, the National Loop Co. 16' Saw Cut Vehicle Detection Loop with 20' of lead-in to reach the detector helps automatic gates sense traffic without any physical contact. A saw, a 1" cut, and a sealant cap put this loop to work in existing pavement. Each loop puts 16' of wire into a 2' x 6' rectangle built for 8' wide driveways, including single-car gravel drives in rural areas and tight older lots.
Part Number: X-NL08-18-20
$102.78 each $102.78 each
OR
 

Details

National Loop Co. 16' (2' X 6') Saw Cut Vehicle Detection Loop with 20' Lead-In for 8' Wide Driveways - X-NL08-18-20

Installing the National Loop Co. 16' Saw Cut Vehicle Detection Loop with 20' Lead-In means sawing one slot, laying in a preformed 18 AWG loop, and sealing it. Working through a compatible loop detector, it detects the metal mass of vehicles above. Installation calls for sawing a 3/16" slot 1" deep into existing asphalt or concrete, laying the loop in the slot, and sealing it, with no hand-winding or turn counting required. Its 6' side spans the travel lane while the 2' side runs in the direction of traffic, leaving roughly 1' of clearance on each edge, an arrangement well suited to older urban row homes, narrow driveways, and single-car gravel drives in rural areas.

Features:

  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
  • Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
  • Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range
  • Neatly stacked turns accept loop sealant completely, locking out moisture for long service life

Specifications:

  • Loop type: Saw cut
  • Total loop length: 16'
  • Loop dimensions: 2' x 6'
  • Lead-in length: 20'
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 8'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL08-18-20?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 20'
Loop Length Size 2' X 6'
Total Loop Length 16'
Wire Size 3/16"
SKU X-NL08-18-20
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file