Details

National Loop Co. 76' (6' X 32') Direct Burial Vehicle Detection Loop with Custom Length Lead-In for 38' Wide Driveways - X-NL38-14

Contractors laying new asphalt, concrete, or gravel can set the National Loop Co. 76' Direct Burial Vehicle Detection Loop with Custom Length Lead-In directly on the sub-base and pave right over it. Teamed with a loop detector, it gives the gate operator the presence detection UL 325 counts as one of its two means of entrapment protection, so the gate reverses or holds open while a vehicle sits in the path. Crews place the loop on the prepared sub-base before paving, and the new asphalt, concrete, or gravel surface locks it in place. Its 32' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to wide equipment yards, grain elevators, agricultural co-op entrances, and large commercial plaza entries.

Features:

• Liquid-tight conduit stands between the wire and sharp stones, chemicals, ground movement, and harsh weather
• Arrives fully assembled and ready to install under new asphalt, concrete, or gravel
• Factory-set turn count means optimal read range without any on-site adjustment
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
• Wound from one continuous, non-spliced wire, leaving no splice point between the loop and lead-in to fail

Specifications:

• Loop type: Direct burial
• Total loop length: 76'
• Loop dimensions: 6' x 32'
• Lead-in length: Custom length
• Wire gauge: 14 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 38'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes