Details

National Loop Co. 48' (6' X 18') Direct Burial Vehicle Detection Loop with Custom Length Lead-In for 24' Wide Driveways - X-NL24-14

Built for sites where saw-cutting is not an option, the National Loop Co. 48' Direct Burial Vehicle Detection Loop with Custom Length Lead-In is a preformed 14 AWG loop encased in liquid-tight conduit. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator the non-contact detection that fills one of the two UL 325 entrapment protection slots. Crews place the loop on the prepared sub-base before paving, and the new asphalt, concrete, or gravel surface locks it in place. With the 18' side crossing the lane and about 3' of clearance per edge, and the 6' side capturing vehicles in the direction of travel, the layout fits 2-car plus full walkway and church or small office lot entries.

Features:

• Arrives fully assembled and ready to install under new asphalt, concrete, or gravel
• Factory-set turn count means optimal read range without any on-site adjustment
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
• Wound from one continuous, non-spliced wire, leaving no splice point between the loop and lead-in to fail
• Heavy-duty, liquid-tight conduit shields the loop from sharp stones, chemicals, ground heaving, and harsh weather

Specifications:

• Loop type: Direct burial
• Total loop length: 48'
• Loop dimensions: 6' x 18'
• Lead-in length: Custom length
• Wire gauge: 14 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 24'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes