Details

National Loop Co. 22' (4' X 7') Direct Burial Vehicle Detection Loop with Custom Length Lead-In for 11' Wide Driveways - X-NL11-14

Every new paving project gains reliable vehicle detection with the National Loop Co. 22' Direct Burial Vehicle Detection Loop with Custom Length Lead-In, a preformed 14 AWG inductive loop. Paired with a compatible loop detector, it senses the metal mass of a passing car or truck and signals the gate operator to open, hold, or reverse, providing one of the two means of entrapment protection UL 325 requires for automated gates. The pave-over design means no slot cutting: the loop goes down on the graded base and the fresh surface finishes the installation. Its 7' side spans the travel lane while the 4' side runs in the direction of traffic, leaving roughly 2' of clearance on each edge, an arrangement well suited to slightly wider suburban single-car drives and older neighborhoods with wider lot cuts.

Features:

• Liquid-tight conduit stands between the wire and sharp stones, chemicals, ground movement, and harsh weather
• Arrives fully assembled and ready to install under new asphalt, concrete, or gravel
• Factory-set turn count means optimal read range without any on-site adjustment
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
• Wound from one continuous, non-spliced wire, leaving no splice point between the loop and lead-in to fail

Specifications:

• Loop type: Direct burial
• Total loop length: 22'
• Loop dimensions: 4' x 7'
• Lead-in length: Custom length
• Wire gauge: 14 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 11'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes