Details

National Loop Co. 76' (6' X 32') Direct Burial Vehicle Detection Loop with 125' Lead-In for 38' Wide Driveways - X-NL38-14-125

Made for new paving projects, the National Loop Co. 76' Direct Burial Vehicle Detection Loop with 125' Lead-In is a factory-wound 14 AWG loop that installs flat on the graded sub-base. Wired to compatible automated system, the loop counts as one of the two means of entrapment protection UL 325 requires for gate operators, detecting the metal of any vehicle over the sensing area so the gate stops or reverses before contact. The pave-over design means no slot cutting: the loop goes down on the graded base and the fresh surface finishes the installation. Its 32' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to wide equipment yards, grain elevators, agricultural co-op entrances, and large commercial plaza entries.

Features:

• Wound from one continuous, non-spliced wire, leaving no splice point between the loop and lead-in to fail
• Heavy-duty, liquid-tight conduit shields the loop from sharp stones, chemicals, ground heaving, and harsh weather
• Fully assembled at the factory, so there is nothing to wind, count, or connect before paving
• Predetermined number of turns removes the guesswork of achieving optimal read range
• Saves labor cost compared with winding a loop by hand in the field
• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters

Specifications:

• Loop type: Direct burial
• Total loop length: 76'
• Loop dimensions: 6' x 32'
• Lead-in length: 125'
• Wire gauge: 14 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 38'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes