Details

National Loop Co. 64' (6' X 26') Direct Burial Vehicle Detection Loop with 30' Lead-In for 32' Wide Driveways - X-NL32-14-30

Contractors laying new asphalt, concrete, or gravel can set the National Loop Co. 64' Direct Burial Vehicle Detection Loop with 30' Lead-In directly on the sub-base and pave right over it. Teamed with a loop detector, it gives the gate operator the presence detection UL 325 counts as one of its two means of entrapment protection, so the gate reverses or holds open while a vehicle sits in the path. The pave-over design means no slot cutting: the loop goes down on the graded base and the fresh surface finishes the installation. With the 26' side crossing the lane and about 3' of clearance per edge, and the 6' side capturing vehicles in the direction of travel, the layout fits light industrial driveways and church or school lot entries.

Features:

• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced wire runs through the loop turns and lead-in, eliminating splice failures
• Liquid-tight conduit stands between the wire and sharp stones, chemicals, ground movement, and harsh weather
• Arrives fully assembled and ready to install under new asphalt, concrete, or gravel
• Factory-set turn count means optimal read range without any on-site adjustment
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system

Specifications:

• Loop type: Direct burial
• Total loop length: 64'
• Loop dimensions: 6' x 26'
• Lead-in length: 30'
• Wire gauge: 14 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 32'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes