Details

National Loop Co. 60' (6' X 24') Direct Burial Vehicle Detection Loop with 200' Lead-In for 30' Wide Driveways - X-NL30-14-200

Sized to match a specific driveway width, the National Loop Co. 60' Direct Burial Vehicle Detection Loop with 200' Lead-In is a factory-wound 14 AWG loop for pave-over vehicle detection. Once a loop detector reads its signal, the loop covers the non-contact vehicle detection that UL 325 requires as one of the two means of entrapment protection for automated gates. Installation is a lay-and-pave job: set the loop on the graded sub-base, run the lead-in to the detector, and let the paving crew cover it. Its 24' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to double-wide commercial entrances, equipment yards, and storage facilities.

Features:

• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced wire runs through the loop turns and lead-in, eliminating splice failures
• Liquid-tight conduit stands between the wire and sharp stones, chemicals, ground movement, and harsh weather
• Arrives fully assembled and ready to install under new asphalt, concrete, or gravel
• Factory-set turn count means optimal read range without any on-site adjustment
• More cost-effective than hand-wound loop installations

Specifications:

• Loop type: Direct burial
• Total loop length: 60'
• Loop dimensions: 6' x 24'
• Lead-in length: 200'
• Wire gauge: 14 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 30'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes