National Loop Co. 52' (6' X 20') Direct Burial Vehicle Detection Loop with 50' Lead-In for 26' Wide Driveways - X-NL26-14-50

National Loop Co. 52' (6' X 20') Direct Burial Vehicle Detection Loop with 50' Lead-In for 26' Wide Driveways - X-NL26-14-50

Keeping an automatic gate both safe and convenient, the National Loop Co. 52' Direct Burial Vehicle Detection Loop with 50' of lead-in wire catches every vehicle that crosses its rectangle. It lays flat on the sub-base of a new drive or lot, and the paving material covers it completely. Its 6' x 20' shape adds up to 52' of wire, the right footprint for 26' wide driveways including 3-car-wide residential drives and light commercial entries.
Part Number: X-NL26-14-50
$210.65 each $210.65 each
OR
 

Details

National Loop Co. 52' (6' X 20') Direct Burial Vehicle Detection Loop with 50' Lead-In for 26' Wide Driveways - X-NL26-14-50

The National Loop Co. 52' Direct Burial Vehicle Detection Loop with 50' Lead-In is a 14 AWG inductive loop that arrives preformed and ready to install, with its lead-in attached as part of the same continuous wire. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator dependable non-contact detection. The pave-over design means no slot cutting: the loop goes down on the graded base and the fresh surface finishes the installation. Its 20' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to 3-car-wide residential drives and light commercial entries.

Features:

  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
  • Wound from one continuous, non-spliced wire, leaving no splice point between the loop and lead-in to fail
  • Heavy-duty, liquid-tight conduit shields the loop from sharp stones, chemicals, ground heaving, and harsh weather
  • Fully assembled at the factory, so there is nothing to wind, count, or connect before paving
  • Predetermined number of turns removes the guesswork of achieving optimal read range
  • Saves labor cost compared with winding a loop by hand in the field

Specifications:

  • Loop type: Direct burial
  • Total loop length: 52'
  • Loop dimensions: 6' x 20'
  • Lead-in length: 50'
  • Wire gauge: 14 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 26'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL26-14-50?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Direct Burial
Lead-In Length 50'
Loop Length Size 6' X 20'
Total Loop Length 52'
SKU X-NL26-14-50
Product Type Direct Burial Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC