Details

National Loop Co. 44' (6' X 16') Direct Burial Vehicle Detection Loop with 175' Lead-In for 22' Wide Driveways - X-NL22-14-175

For driveways getting a fresh surface, the National Loop Co. 44' Direct Burial Vehicle Detection Loop with 175' Lead-In provides vehicle detection without cutting into the finished pavement. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator the non-contact detection that fills one of the two UL 325 entrapment protection slots. The pave-over design means no slot cutting: the loop goes down on the graded base and the fresh surface finishes the installation. Its 16' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to estate homes and small HOA or church parking lot entries.

Features:

• Liquid-tight conduit stands between the wire and sharp stones, chemicals, ground movement, and harsh weather
• Arrives fully assembled and ready to install under new asphalt, concrete, or gravel
• Factory-set turn count means optimal read range without any on-site adjustment
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
• Wound from one continuous, non-spliced wire, leaving no splice point between the loop and lead-in to fail

Specifications:

• Loop type: Direct burial
• Total loop length: 44'
• Loop dimensions: 6' x 16'
• Lead-in length: 175'
• Wire gauge: 14 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 22'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes