Details

National Loop Co. 32' (4' X 12') Direct Burial Vehicle Detection Loop with 75' Lead-In for 16' Wide Driveways - X-NL16-14-75

Sized to match a specific driveway width, the National Loop Co. 32' Direct Burial Vehicle Detection Loop with 75' Lead-In is a factory-wound 14 AWG loop for pave-over vehicle detection. Paired with a compatible loop detector, it senses the metal mass of a passing car or truck and signals the gate operator to open, hold, or reverse, providing one of the two means of entrapment protection UL 325 requires for automated gates. Crews place the loop on the prepared sub-base before paving, and the new asphalt, concrete, or gravel surface locks it in place. Its 12' side spans the travel lane while the 4' side runs in the direction of traffic, leaving roughly 2' of clearance on each edge, an arrangement well suited to common 2-car suburban driveways and small apartment building lots.

Features:

• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced wire runs through the loop turns and lead-in, eliminating splice failures
• Liquid-tight conduit stands between the wire and sharp stones, chemicals, ground movement, and harsh weather
• Arrives fully assembled and ready to install under new asphalt, concrete, or gravel
• Factory-set turn count means optimal read range without any on-site adjustment
• More cost-effective than hand-wound loop installations

Specifications:

• Loop type: Direct burial
• Total loop length: 32'
• Loop dimensions: 4' x 12'
• Lead-in length: 75'
• Wire gauge: 14 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 16'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes