Details

National Loop Co. 18' (3' X 6') Direct Burial Vehicle Detection Loop with 75' Lead-In for 9' Wide Driveways - X-NL09-14-75

The National Loop Co. 18' Direct Burial Vehicle Detection Loop with 75' Lead-In is a 14 AWG inductive loop that arrives preformed and ready to install, with its lead-in attached as part of the same continuous wire. Teamed with a loop detector, it gives the gate operator the presence detection UL 325 counts as one of its two means of entrapment protection, so the gate reverses or holds open while a vehicle sits in the path. Crews place the loop on the prepared sub-base before paving, and the new asphalt, concrete, or gravel surface locks it in place. The 6' side covers the travel lane with roughly 1' 6" of clearance on each side, and the 3' side reads vehicles as they roll through, making it a fit for suburban single-car driveways, condo/townhome parking pads, and small ranch homes.

Features:

• One continuous, non-spliced wire runs through the loop turns and lead-in, eliminating splice failures
• Liquid-tight conduit stands between the wire and sharp stones, chemicals, ground movement, and harsh weather
• Arrives fully assembled and ready to install under new asphalt, concrete, or gravel
• Factory-set turn count means optimal read range without any on-site adjustment
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters

Specifications:

• Loop type: Direct burial
• Total loop length: 18'
• Loop dimensions: 3' x 6'
• Lead-in length: 75'
• Wire gauge: 14 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 9'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes