National Loop Co. 18' (3' X 6') Direct Burial Vehicle Detection Loop with 30' Lead-In for 9' Wide Driveways - X-NL09-14-30

National Loop Co. 18' (3' X 6') Direct Burial Vehicle Detection Loop with 30' Lead-In for 9' Wide Driveways - X-NL09-14-30

The National Loop Co. 18' Direct Burial Vehicle Detection Loop with 30' of lead-in to reach the detector signals the gate operator the moment traffic appears. It goes into the ground before the surface does, buried under new asphalt, concrete, or gravel. Total wire runs 18' in a 3' x 6' pattern made for 9' wide driveways, including small ranch homes and suburban single-car drives.
Part Number: X-NL09-14-30
$130.61 each $130.61 each
OR
 

Details

National Loop Co. 18' (3' X 6') Direct Burial Vehicle Detection Loop with 30' Lead-In for 9' Wide Driveways - X-NL09-14-30

Because it ships fully assembled in heavy-duty conduit, the National Loop Co. 18' Direct Burial Vehicle Detection Loop with 30' Lead-In is ready to lay down the moment the sub-base is graded. Once a loop detector reads its signal, the loop provides the non-contact vehicle detection automated gates rely on. Since the conduit protects the wire, the loop sits directly on the sub-base and gets buried under the new asphalt, concrete, or gravel surface. Its 6' side spans the travel lane while the 3' side runs in the direction of traffic, leaving roughly 1' 6" of clearance on each edge, an arrangement well suited to suburban single-car driveways, condo/townhome parking pads, and small ranch homes.

Features:

  • Factory-set turn count means optimal read range without any on-site adjustment
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
  • Wound from one continuous, non-spliced wire, leaving no splice point between the loop and lead-in to fail
  • Heavy-duty, liquid-tight conduit shields the loop from sharp stones, chemicals, ground heaving, and harsh weather
  • Fully assembled at the factory, so there is nothing to wind, count, or connect before paving

Specifications:

  • Loop type: Direct burial
  • Total loop length: 18'
  • Loop dimensions: 3' x 6'
  • Lead-in length: 30'
  • Wire gauge: 14 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 9'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL09-14-30?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Direct Burial
Lead-In Length 30'
Loop Length Size 3' X 6'
Total Loop Length 18'
SKU X-NL09-14-30
Product Type Direct Burial Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC