Details

National Loop Co. 76' (6' X 32') Direct Burial Vehicle Detection Loop with 50' Lead-In for 38' Wide Driveways - K-NL38-14-50

For driveways getting a fresh surface, the National Loop Co. 76' Direct Burial Vehicle Detection Loop with 50' Lead-In provides vehicle detection without cutting into the finished pavement. Working through a compatible loop detector, it detects the metal mass of vehicles above, satisfying the non-contact detection that UL 325 lists as one of its two required means of entrapment protection. The pave-over design means no slot cutting: the loop goes down on the graded base and the fresh surface finishes the installation. Its 32' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to wide equipment yards, grain elevators, agricultural co-op entrances, and large commercial plaza entries.

Features:

• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced wire runs through the loop turns and lead-in, eliminating splice failures
• Liquid-tight conduit stands between the wire and sharp stones, chemicals, ground movement, and harsh weather
• Arrives fully assembled and ready to install under new asphalt, concrete, or gravel
• Factory-set turn count means optimal read range without any on-site adjustment
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system

Specifications:

• Loop type: Direct burial
• Total loop length: 76'
• Loop dimensions: 6' x 32'
• Lead-in length: 50'
• Wire gauge: 14 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 38'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes