Details

National Loop Co. 64' (6' X 26') Direct Burial Vehicle Detection Loop with 75' Lead-In for 32' Wide Driveways - K-NL32-14-75

Skip the slot cutting entirely: the National Loop Co. 64' Direct Burial Vehicle Detection Loop with 75' Lead-In lays on the sub-base and gets paved over with the new surface. Wired to compatible automated system, the loop counts as one of the two means of entrapment protection UL 325 requires for gate operators, detecting the metal of any vehicle over the sensing area so the gate stops or reverses before contact. The pave-over design means no slot cutting: the loop goes down on the graded base and the fresh surface finishes the installation. Its 26' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to light industrial driveways and church or school lot entries.

Features:

• One continuous, non-spliced wire runs through the loop turns and lead-in, eliminating splice failures
• Liquid-tight conduit stands between the wire and sharp stones, chemicals, ground movement, and harsh weather
• Arrives fully assembled and ready to install under new asphalt, concrete, or gravel
• Factory-set turn count means optimal read range without any on-site adjustment
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters

Specifications:

• Loop type: Direct burial
• Total loop length: 64'
• Loop dimensions: 6' x 26'
• Lead-in length: 75'
• Wire gauge: 14 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 32'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes