Details

National Loop Co. 22' (4' X 7') Direct Burial Vehicle Detection Loop with 50' Lead-In for 11' Wide Driveways - K-NL11-14-50

Sized to match a specific driveway width, the National Loop Co. 22' Direct Burial Vehicle Detection Loop with 50' Lead-In is a factory-wound 14 AWG loop for pave-over vehicle detection. Working through a compatible loop detector, it detects the metal mass of vehicles above, satisfying the non-contact detection that UL 325 lists as one of its two required means of entrapment protection. Because it ships encased in heavy-duty, liquid-tight conduit, the loop lays directly on the graded sub-base and is then paved over under fresh asphalt, concrete, or gravel. Its 7' side spans the travel lane while the 4' side runs in the direction of traffic, leaving roughly 2' of clearance on each edge, an arrangement well suited to slightly wider suburban single-car drives and older neighborhoods with wider lot cuts.

Features:

• One continuous, non-spliced wire runs through the loop turns and lead-in, eliminating splice failures
• Liquid-tight conduit stands between the wire and sharp stones, chemicals, ground movement, and harsh weather
• Arrives fully assembled and ready to install under new asphalt, concrete, or gravel
• Factory-set turn count means optimal read range without any on-site adjustment
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters

Specifications:

• Loop type: Direct burial
• Total loop length: 22'
• Loop dimensions: 4' x 7'
• Lead-in length: 50'
• Wire gauge: 14 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 11'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes