National Loop Co. 20' (4' X 6') Direct Burial Vehicle Detection Loop with 225' Lead-In for 10' Wide Driveways - E-NL10-18-225

National Loop Co. 20' (4' X 6') Direct Burial Vehicle Detection Loop with 225' Lead-In for 10' Wide Driveways - E-NL10-18-225

The National Loop Co. 20' Direct Burial Vehicle Detection Loop with 225' Lead-In sends a signal to the gate controller whenever a car or truck crosses its wire. It sees the vehicle without touching it. Crews place it on the sub-base of a new drive or lot, then pave right over it with asphalt, concrete, or gravel. With 20' of 18 AWG wire laid out 4' x 6', it matches 10' wide driveways, including duplex driveways and small farm entrances, and its 225' lead-in reaches control boxes mounted far from the loop.
Part Number: E-NL10-18-225
$249.90 each $249.90 each
OR

Details

National Loop Co. 20' (4' X 6') Direct Burial Vehicle Detection Loop with 225' Lead-In for 10' Wide Driveways - E-NL10-18-225

The National Loop Co. 20' Direct Burial Vehicle Detection Loop with 225' Lead-In is an 18 AWG inductive loop that arrives preformed and ready to install, with its lead-in attached as part of the same continuous wire. Paired with a compatible loop detector, it senses the metal mass of a passing car or truck and signals the gate operator to open, hold, or reverse. The pave-over design means no slot cutting: the loop goes down on the graded base and the fresh surface finishes the installation. With the 6' side crossing the lane and about 2' of clearance per edge, and the 4' side capturing vehicles in the direction of travel, the layout fits standard single-car suburban homes, duplex driveways, and small farm entrances.

Features:

  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
  • Wound from one continuous, non-spliced wire, leaving no splice point between the loop and lead-in to fail
  • Heavy-duty, liquid-tight conduit shields the loop from sharp stones, chemicals, ground heaving, and harsh weather
  • Fully assembled at the factory, so there is nothing to wind, count, or connect before paving
  • Predetermined number of turns removes the guesswork of achieving optimal read range
  • Saves labor cost compared with winding a loop by hand in the field

Specifications:

  • Loop type: Direct burial
  • Total loop length: 20'
  • Loop dimensions: 4' x 6'
  • Lead-in length: 225'
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 10'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number E-NL10-18-225?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Direct Burial
Lead-In Length 225'
Loop Length Size 4' X 6'
Total Loop Length 20'
SKU E-NL10-18-225
Product Type Direct Burial Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file